Watercolour Common Mistakes
Muddy Colour
Most problems with watercolour can be traced back to either the incorrect use of water or misunderstandings about how the medium behaves. Mastering watercolour is largely a problem-solving exercise. The more you understand what is happening on the paper - and the better you understand your paints - the easier it becomes to avoid, identify and correct issues as they arise.
The usual causes for muddy colour is the use of too much water. Excess water carries pigment deep into the paper surface, causing the colour to diffuse and lose its clarity. Once this dullness has settled into the paper, it is very difficult to remove. If you continue to apply wet washes in the same way, you lose control over your tonal values and the painting becomes increasingly muddy.
Think about it: the more a colour is diluted, the closer it moves towards grey. As it sinks deeper into the paper surface, it becomes softer and more diffused, often taking on a dirty or lifeless appearance.
A better approach is to dampen the paper carefully rather than saturating it. Introduce colour into the damp surface and allow it to flow naturally. Don't be afraid to leave lighter areas or to establish darker tonal areas early in the painting or to use colour in a patchwork way. Strong tonal contrasts help maintain freshness and clarity.

Using too Many Colours in Mixes
Another common mistake is using too many pigments. There is a reason why I recommend a fairly limited palette of primary colours (but not too limited as that creates other problems). If you begin with a multi-pigment colour such as Sap Green and then continually add other colours to it, the mixture can quickly become muddy - it's also difficult to recreate causing inconsistencies in the greens. The same problem can also occur when too many single-pigment colours are mixed together.
Think about it: if you keep adding colours and mixing together of your palette, it will eventually lose its vibrancy and become a dull grey or brown, as shown below.

Often, some layering pigments, as demonstrated in the overlaid wash exercise, creates cleaner and more vibrant colour than mixing numerous pigments together.
There is a great deal of misinformation about mixing greens - so be careful what you take note of. Matching the basic colour of a leaf is only a small part of the process. In many cases, a convincing leaf colour is achieved through the careful layering of several washes of different colours rather than a single mixed green. iSuccess is seldom achieved by trying to get to the 'predominant colour ' too early on in the painting.
Loss of Detail: Highlights and Veins in Leaves
Many students begin by drawing or painting around too many veins. While there are occasions when we need to paint up to veins to preserve them, often they are not clearly visible as distinct lines. Instead, they are suggested by subtle shifts between light and shadow.
Try to stop painting what you know is there and focus instead on what you can actually observe and how the light interacts with the surface. Careful observation is one of the most important skills in botanical painting.
Improve your observation, and you will improve your painting.
It is important to remember that there is no single way to approach veins and highlights. Different leaves have different surface qualities, textures, and vein structures. Some leaves have highly visible venation, while others show very little. The decisions you make should always be based on the specific leaf you are painting.

The video below provides a quick demonstration of how to approach a rose leaf study. The original painting demonstration took approximately 40 mins to complete and has been condensed into around a 20-minute video to highlights several key approaches and techniques. underlying graded washes, adding colour into damp and dry brush. I would probably take around an hour to paint such a leaf to a fully finished stage.
It is worth noting that this Rosa leaf is composed of several small leaflets, so the approach differs from that used for a larger smooth single leaf, where a greater amount of water might be appropriate ( but still not too much) . As a student of botanical art you are learning to problems solve with each subject rather than learning a 'set' formula.... there is no magic formula.

Perhaps the most noticeable aspect of the demonstration is the careful control of water throughout the process. Rather than flooding the paper, I use only the amount of moisture necessary to achieve soft transitions and controlled colour movement. This restraint helps maintain clean, vibrant colour and preserves the crisp details that bring a botanical painting to life.
The leaf goes though quite messy stages at times with patchworks of colour but the blues subtle highlights are retained - if you use too much water - this won't be possible. You will also see thay I often use two brushes - one to apply paint and the other to soften areas - its all quite controlled and much of the detail is added at the end of the painting





Comments